A thorough scrubbing is a must before painting any exterior surface. It removes the dirt and broken-down paint residues that keep fresh coats from adhering and gets rid of mildew that grows on paint in all but the most arid climates. Most contractors clean with pressure washers, but in the hands of someone unfamiliar with the equipment, these can gouge wood, shatter glass, and drive water behind siding and trim. Using a hose, a pump sprayer, and a scrub brush is slower but safer, and just as effective.
PSA: Color psychology is a thing. The right soothing hue can work wonders for your mind and soul. You might think that only works for pale blues, but the contrast of a light and dark color — or, in this case, off-white walls with chocolate brown and deep blue accents — has a powerful effect. "The darker color grounds the room, and then the lighter runs right up to the ceiling and makes it feel higher. It creates this serene atmosphere," designer Laura Bohn told us.
Texas Professional Painting understands that your home, business, or commercial property is important and that a sound painting job protects your investment. Our skilled San Antonio painters are highly experienced and can tackle any project – whether it is stucco, wood, vinyl, or brick. With Texas Professional Painting, you can get peace of mind that every project will be completed promptly and professionally. Your satisfaction guaranteed.
You can typically complete all of these preparations for an entire house in a single day or over a weekend. If you're painting a porch or an outbuilding, it may only take an hour. If you're painting with latex, you can start the following day; solvent-base paint does not adhere well to moist surfaces so wait several days until all the washed surfaces are absolutely dry before applying this type of paint.
house Painting Near Me
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
As you scrape, you may find that the wood has turned gray or black in some areas. Check for rot by probing these areas with a nail. Spots that are discolored but firm are simply weathered. Weathered wood doesn’t hold paint very well, so sand away the gray surface. If you find soft areas, you’ve got rot. Small, shallow soft spots can be dug out and repaired with a two-part filler such as Minwax High Performance Wood Filler. But when rot is deep and widespread, it’s best to replace the entire piece of wood. http://www.youtube.com/watch?feature=youtu.be&v=b6_WEt9k_Hw
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
