When coverage is difficult to estimate, add more rather than less when doing DIY wall painting. You can always pour the leftover back into cans. For large jobs, use the bucket and a roller screen rather than a roller tray. It’s much faster to load your roller with the screen than to use a roller pan. Simply dunk the roller into the paint bucket, then roll it along the screen until it stops dripping.
Depending on just how dirty the outside of your house is and on the house's size, there are two ways to approach this job. If you live in an average-size house, use a garden hose with a carwash brush attachment to bathe the big areas. For caked-on dirt, use a scrub brush or a sponge and a pail of warm water with a good, strong household detergent in it. Work from the top down, and rinse all areas where you scrubbed with water.
As a former professional painter, something that drives me crazy is when I see painters cut in around wall plates. First of all, the amount of time that it takes to cut in is usually much longer than the amount of time that it takes to simply remove the wall plate. Secondly it does not look nearly as clean as it does when the wall plate is removed and thirdly it can invariably leave paint on the wall plate itself which also looks sloppy. Make sure the painter takes them off and then reinstalls them. It's less time.
The obvious trick here is for unaffiliated contractors to use the BBB, PDCA, Chamber or other organizations’ logos without being a member. Other tricks include claiming membership when that membership has expired or even make up fake organizations that sound good. The BBB continuously goes after unscrupulous companies that attempt to trick customers into thinking they are members. Nearly every organization has a web page these days; if you suspect something, do a little searching to find out the truth.house Painting Cost
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.
The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
A primer 3 is essentially a protective layer that you apply before the first coat of paint. If you are painting over an already-painted surface, you may be able to avoid a primer 3 altogether by using a 2-in-1 paint and primer product. However, if you are painting a surface that has never been painted before or changing the paint or finish type, it would be a good idea to prepare the surface using a traditional primer 3. Primers 3 should also be used when painting over hard, smooth surfaces like glass or tile. All three types of primers 3, oil-based, latex-based and shellac-based can be used under latex paint.
