Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
You can typically complete all of these preparations for an entire house in a single day or over a weekend. If you're painting a porch or an outbuilding, it may only take an hour. If you're painting with latex, you can start the following day; solvent-base paint does not adhere well to moist surfaces so wait several days until all the washed surfaces are absolutely dry before applying this type of paint.
house Painting Images
Our painters handle everything from re-painting a half-bath, painting a door and re-glazing windows to painting 30,000 square foot commercial office buildings. We paint many surfaces from wood to aluminum, as well as maintain finishes on fences and decks and provide any necessary minor carpentry needed to complete projects. We can paint your bathroom or kitchen tile, your wood paneling, and your kitchen and bath cabinets. We can handle almost any painting project, large or small.
To determine how much paint your house needs, measure the house's perimeter. Then multiply that figure by the height, excluding gable ends. Take the measurements with a steel tape measure, or reel out a ball of twine around the house and mark and measure the twine. If you will use a different paint on your home's trim, subtract 21 square feet for every door and 15 square feet for each typical window. Divide the final figure by the square-foot coverage specified on the can of paint to determine the number of gallons you will need for one coat.
interior House Paint Colors Pictures
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
