to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
exterior Wall Painting
To remove a bad piece of siding, you have to pull out two rows of nails: the ones in the bad board itself, and those in the board directly above. Siding is thin and splits easily, so the tricky part of this job is pulling nails without damaging surrounding boards. A cat’s paw is the best tool for digging out nails if damage to the surrounding wood doesn’t matter (Photo 1).
Project management is important for contracted painting jobs because it helps with communication and lowers the chance of complaints. The fact is, contracting is the #1 source of consumer complaints in the state and project management is what triggers most calls to the State Contractor’s License Board and the Better Business Bureau. With a proper project management system in place, these complaints can be avoided and your job will be completed the right way. https://www.youtube.com/e/b6_WEt9k_Hw?app=desktop
Historically, the painter was responsible for the mixing of the paint; keeping a ready supply of pigments, oils, thinners and driers. The painter would use his experience to determine a suitable mixture depending on the nature of the job. In modern times, the painter is primarily responsible for preparation of the surface to be painted, such as patching holes in drywall, using masking tape and other protection on surfaces not to be painted, applying the paint and then cleaning up.[2]
house Painting Tips
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
