To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
When the primer is dry, caulk all small joints (less than ¼-inch-wide) in the siding and trim. Most pros use siliconized acrylics—paint won't stick to straight silicones—but Guertin and O'Neil like the new, more expensive urethane acrylics for their greater flexibility and longevity. O'Neil stresses that it's shortsighted to skimp on caulk. "If the joint fails, you're back to square one." Guertin uses the lifetime rating as his quality guide. "I don't expect 35-year caulk will last 35 years, but it should last longer than a 15-year caulk."
