I've seen this article sent out 4 times now. It's out dated in terms of today's "Scams." Paint stores haven't charged more money for deeper paint colors in over 15 years. Also Water downed paint? Seriously? That would never happen in the real world. And Wall repair? what painter would ever not assume wall repair as included? This article is a waste of time and should be taken down or edited to reflect actual scams of todays times.
Freshly painted walls often look blotchy. The color is uniform, but the sheen isn’t consistent. This usually occurs over the holes and cracks you patched with a filler or drywall compound. The porous fillers absorb the paint, dulling the surface (a problem called “flashing”). When light hits these dull spots, they stick out like a sore thumb. The smooth patch also stands out in contrast to the slightly bumpy texture of the rest of the wall. A quick coat of primer is all it takes to eliminate flashing and texture differences.
To maintain a wet edge, start near a corner and run the roller up and down the full height of the wall, moving over slightly with each stroke. Move backward where necessary to even out thick spots or runs. Don’t let the roller become nearly dry; reload it often so that it’s always at least half loaded. Keep the open side of the roller frame facing the area that’s already painted. That puts less pressure on the open side of the roller, so you’re less likely to leave paint ridges when doing DIY wall painting.
Using an airless sprayer to place paint on the wall (using low pressure) will speed up the process because your not having to dip your brush or roller. spray about 3 or 4 sq. ft. and then back brush or roll spreading and evening the paint. Because your using low pressure, mask and cover is at a minimum once you are accustomed to handling the spray gun and the type of surface being painted. Overspray will be larger droplets they tend to fall, than float around.
home Painting App
To paint a large section without leaving lap marks, roll the nearly dry roller in different directions along the dry edge, feathering out the paint as you go. After completing the entire length of the wall or ceiling, move to the next section and paint over the feathered edges. For the second coat, apply the paint in the opposite direction. This crisscrossing paint application sharply reduces (if not eliminates) lap marks.
