Deciding which paint to use has gotten much easier now that acrylic latexes have pushed oil-based paints almost to extinction. The acrylics offer superior performance (they don't harden with age, the way oils do, so they move and breathe without blistering), they don't mildew as readily, and they emit fewer VOCs, so they comply with new air-quality regulations. They also work over both oil- and water-based primers.
As you walk through your lighted rooms (preferably day light) see if the new coat has light spots showing the precious paint. This is call "bleeding through". This means that there's only one coat of paint or the paint was diluted or the trasition of colors were from light to dark (or the other way around) and primer was not use or the painter is inexperienced.
Depending on just how dirty the outside of your house is and on the house's size, there are two ways to approach this job. If you live in an average-size house, use a garden hose with a carwash brush attachment to bathe the big areas. For caked-on dirt, use a scrub brush or a sponge and a pail of warm water with a good, strong household detergent in it. Work from the top down, and rinse all areas where you scrubbed with water. https://youtube.com/embed/b6_WEt9k_Hw
NOTE: Member service professional information confirmed as described above may change or expire over time; while HomeAdvisor attempts to maintain accurate and up-to-date information, and confirms changes when notified, we cannot guarantee that profile and screening information is accurate. Therefore, we recommend that before working with a service professional you verify that information presented is still current and/or acceptable to you. http://www.youtube.com/v/b6_WEt9k_Hw
Before the scrubdown, protect nearby plants by misting their leaves and saturating the surrounding soil with water, pulling them away from the house, and shrouding them in fabric drop cloths. (Plants will cook under plastic.) Lay more drop cloths along the base of the walls to collect any falling paint debris. Walls should be wet down before getting scrubbed, then washed with a gallon of water mixed with 1 cup chlorine bleach and 1 cup of either a concentrated, phosphate-free cleaner, such as a trisodium phosphate (TSP) substitute, or Jomax House Cleaner. Working in sections, from the bottom to the top, will avoid streaks. Be sure to rinse walls well before the solution dries. Wood siding and trim should be ready to paint after a day or two of dry weather.
• One room or the whole house? Applying one coat in one room is a reasonable DIY Saturday project (especially if you have help and beer). Multiply the time spent moving furniture, prepping walls and sanding old trim by the number of rooms in the house, and you might want to hire real help. It's the same outside. You can probably tackle one shady garage wall that needs a little scraping and sanding plus a coat of paint, but covering all surfaces of the house is usually best left to a pro.
The other difficult part is getting a painting contractor to show up. While this generalization does not apply to every painter, personally I am extremely grateful if I can get a paint contractor to show up to look at the house and to later produce a written estimate. I hardly fault the painting contractors, because I think it is a combination of the contractors being smaller operations along with a high demand for their work. http://www.youtube.com/watch?feature=youtube_gdata&v=b6_WEt9k_Hw
If you are going to hire a contractor (professional painter) give a room by room punch list of the fixing of holes small or big, have it identified for the painter to tell you if you need a drywall finisher or if he does this type of work good. Wall repairs can be 3-5 steps to do repairs ( one per day for good drying of patching material and a good sanding) this is what gives you a good paint job only using high quality paint.
interior And Exterior Painting Services Near Me
This feared question gets to the heart of who will be performing work in your home and whether your home and belongings will be safe. Sadly, there have been numerous documented cases around the country where employees of a hired contractor have burglarized, injured, or even killed the homeowner. What’s worse, in most cases it was later found that the bad employee had a criminal background that was unknown to the employer. In learning about who will be performing the work in your home, you should ask additional questions about their hiring policy and whether they conduct criminal background checks.
Also prime the ends of adjoining boards. This step pays off by slowing the moisture penetration that can lead to peeling at the joints. If the new siding is redwood or cedar, buy a special “stainblocking” primer. Both of these woods contain natural chemicals (tannins) that can bleed through paint, causing brownish stains. A stain-blocking primer will seal in the tannins.
You can use the spray cleaner while working from a ladder -- although scaffolding is better -- but practice at ground level first; the force of the spray against the house could knock you off a ladder if you're not careful. Some of these machines come with separate containers you can fill with cleaning solutions or anti-mildew solutions. Sprayers are so powerful that ordinarily you probably won't need to use a cleaning solution; if you do, remember to rinse the surface with clean water afterward.
The companies with the best paint products are Benjamin Moore, Dunn Edwards, Sherwin Williams, and Vista Paint. As a painter I don't recommend Berh from Home Depot as much because it's quality is just marketing. Flat paint has no sheen and it shows its true color, but is not easy to wash or clean. Satin, eggshell have low sheen and is washable. Semigloss ang glossy has a high sheen and these paints are recommended for bathrooms and kitchen or where there's high humidity and steam.
First off, the picture on the top THAT IS A HOME OWNERS PAINT JOB. If you here a school kid or your neighbor, this is what you get. I was a painting contractor for the better part of 40 years and never saw a PAINTER (even the worst painter) leave a mess like that. Maybe the electrician or the carpenter but, that is not something a painter could even do if they tried.
