Labor costs for painting vary widely, depending on region, season, type of painting project, and experience level. On an average, you can expect to pay around $50 per hour for house painting projects. However, highly experienced painters can charge up to $70 per hour for specialty projects like murals. A 2,300 sq.ft. single-story home will require around three to five painters to paint the entire house and will take a minimum of five days to complete for a total cost of $2,400-$7,000. http://youtube.com/e/b6_WEt9k_Hw?app=desktop
Start by thoroughly examining the outside of the house or outbuilding -- not just the exterior walls but under the eaves, around windows and doors, and along the foundation. Look for split shingles and siding, popped nails, peeling or blistering paint, mildew, and rust stains. Once you've identified the areas that need attention, roll up your sleeves and make the repairs.
Concrete walls must always be prepared before painting, but in some cases previous finishes will also have to be removed so that paint doesn't peel or chip off. Additionally, special sealants, primers and paints may be applied to ensure concrete's endurance in face of the specific elements. Depending on the wall's condition and exposure to the sun, painting professionals will usually estimate between $500 (~250 sq. ft.) and $2,000 (~1,000 sq. ft.), depending on wall area to cover.
Second coats on similar colors are almost never recogicnized as being needed until the coat is applied and has dried. ONLY THEN WILL YOU SEE WHETHER IT NEEDS A SECOND COAT or not. Yes, painters can use a cheaper paint then what you paid for. That is solved by getting your own which, I would charge extra for because I will always have to go get more, or add second coat because home owner tried to skimp on paint, or they got the wrong color etc... https://youtube.com/watch?feature=player_embedded&v=b6_WEt9k_Hw
Not all people live where they can hire a painting contractor, like you describe. People who live in small towns can only hire painters who have a very small business, and do two or three paint jobs per week. In this case, you do have to be very careful, when you hire a painter, as we have several, in our area, who are out to make a fast buck anyway they can.
Use spray paint to refinish your old bicycle or give any surface a new finish - glitter, mirror or just a new solid color. A fresh coat of concrete paint on a basement walls can make a huge difference. Protect your garage floors from dirt and stains with an epoxy paint. Don’t forget your bookshelves — douse them with some furniture paint to make them look new, again.
• One room or the whole house? Applying one coat in one room is a reasonable DIY Saturday project (especially if you have help and beer). Multiply the time spent moving furniture, prepping walls and sanding old trim by the number of rooms in the house, and you might want to hire real help. It's the same outside. You can probably tackle one shady garage wall that needs a little scraping and sanding plus a coat of paint, but covering all surfaces of the house is usually best left to a pro.
When you go to the home improvement store, find out how much 12 gallons of the paint you want would cost, and that will help you determine your cost. Maybe it's a low-quality paint that costs $30, in which case you're looking at about $360 for paint. If you choose high-quality paint that costs around $70, your total paint cost could be closer to $840. Professionals also recommend that you add an extra 10 or 20 percent to your total square footage, depending on the type of siding you have. Some textures require extra paint because they're rough. This is especially true with wood and stucco siding. http://www.youtube.com/watch?v=b6_WEt9k_Hw&feature=youtube_gdata
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
Not all people live where they can hire a painting contractor, like you describe. People who live in small towns can only hire painters who have a very small business, and do two or three paint jobs per week. In this case, you do have to be very careful, when you hire a painter, as we have several, in our area, who are out to make a fast buck anyway they can.
Alamo took almost 7 hours (with a 3 hour break) and then when they came back they had no instillation (as in our proposal) for the ceiling I had repaired and found out after, that the insurance company never fixed the roof. So for the last three years wet installation removed as much as possible it was covered in plastic with no instillation. Finally....3 Years later We called Alamo Paint contractors and were pleased with the head Forman and took the proposal ( drywall, paint, new instillation, texturing, plus banister repair). Needless today what normally took a three hour job ( from our last experience), took from 9am-4pm. The banister we also had repaired by his assistant was only a 30-40 min job and that was perfectly done. The texture on the ceiling was so-so only because you can see the drywall tape under the paint. I?m having a new painter fix this so it can at least look better then drywall tape showing. Alamo are very nice, good people skills but poor workmanship considering all that happened. https://www.youtube.com/watch?v=b6_WEt9k_Hw&app=mobile
Paint gets more expensive as you go from flat to gloss. The difference is usually around $1 per gallon per sheen upgrade. Flat is the cheapest, then matte flat or eggshell, satin, semigloss then gloss. Paint also gets much more expensive the darker it gets. A white or neutral paint color can be as much as $20 less expensive than a deep base red or blue. https://www.youtube.com/embed/b6_WEt9k_Hw
Keep an eye on the new cans as they're being brought in. Make sure they look new and don't have paint in the rim of the can. If it's a five-gallon bucket, check to see whether the lid is still sealed on with the plastic strip. The only time it's acceptable to mix water in the paint is when you're using a deep or ultra deep base paint to reduce its stickiness, which is rare with new paint technology. Dark primary colors are composed almost entirely of tint that makes it very hard to work with without adding water.
Payment. Every client is different. Every job has it's own unique set of circumstances. I always start off the discussion with my clients saying that I'm flexible on how they would like to proceed with payments but that I prefer half down. I refuse to change order. Change orders are my last resort. Instead I ask questions at our initial meeting and try to be sure to cover all bases before I submit my estimate.
Ideally, you want a variety of older and newer projects, and you especially want to check on a very recent project, such as something completed last month. When you do get the references list, don’t take the information for granted. Take a few minutes to check these references. Ask these homeowners about the experience while services were provided and also how well the job has held up over time.
