The materials of the home’s facade should be considered before painting your home. When painting flat surfaces like siding or wood, you can opt for standard outdoor paint. When painting a textured surface like stucco or brick, “elastomeric” paint is a much better choice. This type of paint can stretch more than normal paint, which allows it to bridge over small gaps and crevices, painting smoothly over texture.
Over the past year I have had several jobs given to 2 Angie's list recommendations and 1 not from a recommendation. They all have one thing in common, lack of sufficient and correct preparation to save time, labor, and the fact that they put a person in charge that was a cut corners type of worker. The two from Angie's list sent worker/s back to try touch up problems, but once the job is not prepared correctly in the first place any extra work is like putting a band-aid on a dirty wound.
As you scrape, you may find that the wood has turned gray or black in some areas. Check for rot by probing these areas with a nail. Spots that are discolored but firm are simply weathered. Weathered wood doesn’t hold paint very well, so sand away the gray surface. If you find soft areas, you’ve got rot. Small, shallow soft spots can be dug out and repaired with a two-part filler such as Minwax High Performance Wood Filler. But when rot is deep and widespread, it’s best to replace the entire piece of wood. http://www.youtube.com/watch?feature=youtu.be&v=b6_WEt9k_Hw
The walls must be properly cleaned prior to applying primer or paint. This involves using a mixture of soap and water. Nail holes, chips, cracks or other small imperfections should be filled in and evened with plaster and allowed to dry before the entire surface is lightly sanded down and wiped again. Once the wall is clean and dry, you should apply painter’s tape over surfaces you do not want painted. Be sure not to overlook ceiling corners and edges, baseboards and trims and moldings.
house Outer Painting Exterior Painting
If there is any peeling — and there usually is somewhere — it's essential to scrape off any loose paint. This doesn't just mean the parts that are already separated from the wood and ready to fall off on their own. Each spot where paint has peeled loose needs to be scraped thoroughly until you can no longer get the sharp corner of a putty knife under any of the surrounding edges of paint. Then, the bare spot needs to be sanded until the paint edges are smooth.
Professional painters provide estimates primarily based on the square footage of your home. Painting an average home between 500 and 1,500 square feet can cost between $1,000 and $3,000. However, factors such as number of stories and ease of access can also affect the overall price. Homeowners report that the average cost to paint a house nationally is $2,581 and most pay between $1,714 and $3,682. https://www.youtube.com/attribution_link?a=b6_WEt9k_Hw&u=%2Fwatch%3Fv%3DXXXXXX%26feature%3Dshare
To determine how much paint your house needs, measure the house's perimeter. Then multiply that figure by the height, excluding gable ends. Take the measurements with a steel tape measure, or reel out a ball of twine around the house and mark and measure the twine. If you will use a different paint on your home's trim, subtract 21 square feet for every door and 15 square feet for each typical window. Divide the final figure by the square-foot coverage specified on the can of paint to determine the number of gallons you will need for one coat.how Much To Paint Contractor
