to be the devils advocate i have been a building contractor 20 of the last 30 yrs. i do know that if you go to a higher sheen of paint and or darker colors then any imperfections in the walls will show up much more dramatically…therefore the painter or a good drywall finisher is needed to prepare the walls extensively. this could cause more expenses…for it takes a lot of time to prep walls (smooth walls..not textured walls) and this cost has to be absorbed.
painting House Cost
It is often necessary to have a rental property painted -- whether it's to make it your own before you move in or to clean it up for someone new when you move out. Some buildings and landlords have pre-selected painters, while others will contract companies to paint on an as-needed basis. If your landlord or building doesn't have a pre-selected painter, see if you may be allowed to paint the walls yourself. If you're moving in and selecting a non-neutral color, understand that your landlord may require you to repaint the walls the original color when you move out -- and ensure that you're ready to make that investment down the road.
You can typically complete all of these preparations for an entire house in a single day or over a weekend. If you're painting a porch or an outbuilding, it may only take an hour. If you're painting with latex, you can start the following day; solvent-base paint does not adhere well to moist surfaces so wait several days until all the washed surfaces are absolutely dry before applying this type of paint.
Even if you go it alone, specialize to keep your initial investment low. If you do only interior painting, for example, you might get by with one ladder, a few brushes, rollers, basic hand tools and such, for an investment of less than $300. Again, you can add to your tools as you need to (every job is a bit different), and parlay profits into the equipment necessary for exterior painting or working on large commercial properties.
Next, undercut the trim to create a gap (Photo 3). When you’re done, scrape any dirt or gunk out of the gap with a putty knife and blow out the dust using a vacuum or air compressor. To avoid staining the concrete, run at least three layers of masking tape under the wood. Apply repellent to all bare wood (Photo 4) including the underside (Photo 5). Bend a putty knife in a vise to make a handy tool for reaching into tight areas. Remove the tape right after application.
Ideally, you want a variety of older and newer projects, and you especially want to check on a very recent project, such as something completed last month. When you do get the references list, don’t take the information for granted. Take a few minutes to check these references. Ask these homeowners about the experience while services were provided and also how well the job has held up over time.
