Use spray paint to refinish your old bicycle or give any surface a new finish - glitter, mirror or just a new solid color. A fresh coat of concrete paint on a basement walls can make a huge difference. Protect your garage floors from dirt and stains with an epoxy paint. Don’t forget your bookshelves — douse them with some furniture paint to make them look new, again.
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
This article is outdated. Deep based colors were an increase in price back in the 90's. Most stores have a standard price for all colors now. The problems the author are citing are outdated and rarely happen. This is the 2nd time I've seen this article being emailed out, it's irresponsible of angies list to keep sending out this poorly written and inaccurate article.
For bigger houses or for faster work on smaller ones, rent a high-pressure spray cleaner. This device attaches to your home's water-supply system and puts out a jet of water at a pressure of about 600 pounds per square inch. It is equipped with a handheld wand tipped with a trigger-activated nozzle. The pressure is high enough to dislodge not only stubborn dirt, mildew, stains, and dried-on sea-spray salt, it's enough to remove peeling paint. In fact, if the jet nozzle is held too close to the surface it can even peel off perfectly sound paint, split open shingles, and drill a hole in siding. So follow the manufacturer's directions and wear goggles and protective clothing.
These are some fantastic questions to ask and I particularly like the one that is concerned about safety for the painters. After all, if you have a large home and you’re hiring them to paint the exterior of that home then they’ll likely be on scaffolding. Because of that, you need to make sure that the contractor not only provides appropriate safety training, but has the correct liability insurance as well.
To determine how much paint your house needs, measure the house's perimeter. Then multiply that figure by the height, excluding gable ends. Take the measurements with a steel tape measure, or reel out a ball of twine around the house and mark and measure the twine. If you will use a different paint on your home's trim, subtract 21 square feet for every door and 15 square feet for each typical window. Divide the final figure by the square-foot coverage specified on the can of paint to determine the number of gallons you will need for one coat.
